QAR: Click Here
Conditions for approval required by: Julien Gauther
Certification of Aerospace Products to international quality Standards
Certification of Aerospace Products to international quality Standards
Form restricted to registered, logged in users. Please return to the home page and use the Create Account option.
In QTP, could you please replace ISO8788:2000 by ISO8788:2020? (Note: in QTR, ISO8788:2020 is mentioned)
Cadmium plating: may we get the baking curve after plating? (Baking to prevent any hydrogen embrittlement). Hopefully, Protec does mention in their CoC that these parts have been degassed.
Many thanks in advance,
Best regards.
• In QTP, could you please replace ISO8788:2000 by ISO8788:2020? (Note: in QTR, ISO8788:2020 is mentioned).
QTP has been replaced to correct the typo (ISO8788:2000 into ISO8788:2020). The QTP is now revision 1.
• Cadmium plating: may we get the baking curve after plating? (Baking to prevent any hydrogen embrittlement). Hopefully, Protec does mention in their CoC that these parts have been degassed.
The Protec “Baking curve” after Cadmium plating is added to the Additional Documents of this report.
The updated document “Protec, baking curve after plating” is included in the “Additional Documents” section of this report.
When asked, PROTEC indicated that this was a calculation error and they have corrected this calculation error in the updated version.
Many thanks to you Kees and Protec as well, for this correction.
All is clear for me now, so approved on my side.
Best regards.