QAR: Click Here
Conditions for approval required by: Julien Gauther
Certification of Aerospace Products to international quality Standards
Certification of Aerospace Products to international quality Standards
Form restricted to registered, logged in users. Please return to the home page and use the Create Account option.
Dimensions (page 22 of 45): just a remark, not blocking: “Not applicable on nuts without recess”. Counterbore is more appropriate than recess.
Raw material: in “standards issue” section, it is written that raw material is in line with EN2543.
However, raw material CoC (PATURLE) does not mention EN2543 standard. This CoC is compliant to SAM0004/O. Could you please explain the link between SAM0004/O and EN2543?
Cadmium plating: in QTP and QTR, EN2133:2012 is mentioned whereas in cadmium plating CoC (HFS MECAERO), EN2133:2020 is mentioned. This is not blocking, just to be clarified.
Many thanks in advance,
Best regards.
Dear Julien,
please find below my feedback,
-Dimensions: “J” measurements during audit => 4,6 mm Max : 3,46 mm-3,45 mm – 3,50 mm.
-Please find enclosed the Howmet’s raw material specification SAM0004, covering EN2543 specification.
-Indeed, for Cadmium plating, EN2133:2020 is mentioned on plating CoC (HFS Mecaero), so EN2133:2020 should have to be mentioned in QTP & QTR.
Thank you in advance for your treatment,
S.Garcia
Dear Sébastien,
Many thanks for your quick reply.
I am happy with all answers, so, approved on my side.
Best regards.